2/28/2023 0 Comments Side seam 1piece moccasin patternI thought I’d jazz these slippers up a bit by adding some details to the top of the toe with a striped eyelet/chevron combo. Insert the thin strip through the slits and tie the moccasin.This is another version of my very popular Adult Moccasin Slippers. Cut two vertical slits at the back of the moccasin with leather shears or a leather knife. Make sure the strip is long enough to tie around your ankle. This step is optional.Ĭut a thin strip along the edge of the leather or suede. Stitch trim such as fringe or beads at the back heel. Do not cut the slit until you try on the moccasins. Try on the moccasin for comfort and fit.Ĭut an angled “V” slit at the back of the heel. The raw seams will be inside of the moccasin boot. If you are working with heavy weight leather or suede, change the sewing needle to a leather needle to avoid breakage. Points “B,” “C,” “D” and “E” are matched up as you stitch. Though cutting fabric scraps is optional it gives you the opportunity to ensure the moccasin fits prior to cutting out project fabric such as leather or suede.įold along the center line made in step 1. Pin the pattern with straight pins on scrap felt or fabric and cut out two pieces with scissors. Make sure the center point of the curved line is at least 1/4 inch away from the edge of the paper.Ĭut out the paper pattern along the outer lines. Mark the end point of the line as “C.”Ĭonnect point “C” to “D” by drawing a curved line with a French curve ruler. Draw a line to the bottom of the pattern paper maintaining the 2-inch measurement. Measure 2 inches from point “B” and draw a perpendicular line. The cuff will be folded along the ankle, using the angled line as the folding guide. Position the ruler on a 90-degree angle on point “B.” Draw a line until it meets with the end of the line from step 7. Mark the pattern point as “B.”ĭraw a vertical line from the little toe marking down to the heel. Position the ruler horizontally at the little toe marking and measure 1/2 inch. Draw a horizontal line from the little toe marking on each side of your feet Draw around the toes using a 1/2-inch distance from the large toe to the outer ball of the foot. Measure 1/2 inch from the toes to the edge of the pattern paper with a ruler. Slightly angle the pencil upwards from the base of the toe to the center line. Set the balls of your feet 1/4 inch apart. Mark the distance from the edge of the paper to the heels as pattern part “D.” Mark the distance between the heels as pattern part “E. The inner portion of the heels are 1/2 inch apart. Make sure your heels are 1 inch apart and are 1 inch away from the edge of the paper. Position your feet on either side of the line drawn on the pattern paper. Make sure the pattern paper is large enough for you to stand on. This will be the moccasin center-seam fold line in a later step. Trims such as fringe, beads or cutouts are inserted at the heel of the moccasin as well as decorative stitches like whip stitching.The extended ankle piece is folded over to complete the moccasin, and a leather strip is tied around the ankle to hold the moccasin in place.ĭraw a center line on pattern paper with a drafting pencil. Brain Tan Leather is used for the moccasin. Tracing feet and making a pattern is the basis of constructing a pair of center-seam eastern woodland indian moccasins.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |